NEC express5800 A2010b - Page 367

7. Using Remote Management
Chapter 3 Setup
Item name
Description
Setup value
Default setting(*1)
SEL
Behavior when
SEL repository
is full (*2)
Specify the logging
method of new
event log (SEL)
when SEL
repository is full.
Stop logging SEL (*3)
New event is not logged when
SEL repository is full. This
setting can be used on the
server where NEC ESMPRO
Agent is installed. NEC
ESMPRO Agent takes up SEL,
and then clears SEL. If NEC
ESMPRO Agent is not installed,
new event log cannot be
collected.
Stop logging SEL
Clear All SEL
All the event logs are cleared
when SEL repository becomes
full.
Overwrite oldest SEL
The oldest log is overwritten by
new log when SEL repository is
full.
Access Log
(*4)
Interface
Specify an event to
be registered in
Access Log.
Enable/Disable
Disable
HTTP
Enable/Disable
Disable
HTTPS
Enable/Disable
Disable
SSH
Enable/Disable
Disable
Power
Option
AC-LINK(*5)
Specify the DC
power mode when
AC power is off.
Stay Off
Does not turn DC power on.
Last State
Last State
Restore the DC state before
AC-Off.
Power On
DC power is always turned on.
Delay Time
(sec)(*6)
Specify the delay
time from AC ON
to server power on
(in seconds).
Setting of delay
time can be
changed when
[Last State] or
[Power On] is
selected for
[AC-LINK].
45 to 600
Select Random of Manual
Setting to specify delay time.
Manual Setting: Select this item
to set delay time manually.
Available values are between 45
and 600 seconds.
Random:
BMC sets random value in the
range between 45 and 600
seconds.
45
PEF (*7)
Platform Event
Filtering
Enable or disable
SNMP Alert (PEF).
When set to
Disable, SNMP
alert is not sent.
Enable/Disable
Enable
Express5800/A1040b, A2040b, A2020b, A2010b User's Guide
367