NEC SL1100 - Page 224

Issue 6.0 NEC SL1100
10 - 12 IP Single Line Telephone
2.2.8 NAT Mode for Standard SIP terminal (Version 4.0 or higher)
15-05-40
IP Telephone Terminal Basic
Data Setup – Calling Name
Display
0 = Both Name and
Number
1 = Name only
2 = Number only
3 = None
Default = 0
X
15-05-41
IP Telephone Terminal Basic
Data Setup – Time Zone
0 ~ 24
(-12 ~ +12 hour)
Default = 12
X
15-05-43
IP Telephone Terminal Basic
Data Setup – Video Mode
0 = Disable
1 = Enable
Default = 0
X
15-05-44
IP Telephone Terminal Basic
Data Setup – Using STD-SIP
Display for CPN
0 = Disable
1 = Enable
Default = 0
X
15-05-49
IP Telephone Basic Setup -
Receiving SIP INFO
Determines whether
SIP INFO messages
are received by the
system.
0 = Disable
1 = Allowed any time
2 = Allowed while RTP is
not available
Default = 2
Program
Number
Program Name
Description/
Comments
Assigned Data 1 2 3
Program
Number
Program Name
Description/
Comments
Assigned Data 1 2 3
10-12-03
CPU Network Setup
– Default Gateway
Assign the IP Address for
the Router.
0.0.0.0 ~ 126.255.255.254
128.0.0.1 ~ 191.255.255.254
192.0.0.1 ~ 223.255.255.254
Default is 0.0.0.0
X
10-12-07
CPU Network Setup
- NAPT Router IP
Address (Default
Gateway [WAN])
Define the IP Address of
the WAN side of the
router.
0.0.0.0 ~ 126.255.255.254
128.0.0.1 ~ 191.255.255.254
192.0.0.1 ~ 223.255.255.254
Default is 0.0.0.0
X
10-12-08
CPU Network Setup
- ICMP Redirect
When receiving ICMP
redirect messages, this
determines of the IP
Routing Table updates
automatically or not.
0 = Enable
1 = Disable
Default is 0 X