Figure 127 – Advanced Setup > LAN page
4 Click the Add Entries button.
5 Enter the MAC address of the computer/device you are connecting to the router. The MAC address is a 12 character
set of numbers and letters (A-F), where every 2 characters separated by a colon (:).
6 Enter the IP address of the computer/device. This is the local address in the range of 192.168.20.x where x = a number
between 2 and 254.
Figure 128 – DHCP Static IP Lease details
7 Click the Apply/Save button.
8 Complete steps 4 through 7 for each device connected to the NF18ACV router. Each entry will be listed in the Static IP
Lease List as shown below.
To Next Page
Loading...
