DSL Advanced settings
For advanced DSL options press the Advanced Settings button.
The DSL advanced settings relate to test mode settings. The default selection is Normal.
Figure 77 – DSL Advanced Settings page
Puts the modem in normal operation mode.
Puts the modem in a test mode in which it only sends a Reverb signal.
Puts the modem in a test mode in which it only sends a Medley signal.
In this mode, the modem will try to establish a connection as in normal mode,
but once the connection is up it will not retrain if the signal is lost.
Puts the modem in the Link state (Idle) at the start of the initialization
procedure.
Click the Apply button to initiate the change.
Allow selection of frequency band for data transfer.
Table 26 – DSL settings table
To Next Page
Loading...
