NetCommWireless NF18ACV User Manual

38 of 131
User Guide
© NetComm Wireless 2017
WAN Service
The WAN Service page displays the current Wide Area Network service setup and allows you to configure the router to
connect to a larger network for Internet access.
Attention – WAN service requires a preconfigured Layer 2 interface, be it ATM/PTM or Ethernet WAN.
Figure 33 – NF18ACV router
To add a WAN service, click the Add button.
Use the drop down list to select the layer 2 interface to use for the WAN service and click the Next button.
Figure 34 – WAN Service – Select layer 2 interface
Select a WAN service type, enter a Service Description, enter the 802.1P Priority and 802.1Q VLAN ID if required, then click
the Next button.
To disable VLAN tagging, place input value of -1. Refer to your ISP for VLAN information as required by your Internet Service
Provider.

NetCommWireless NF18ACV Specifications

General

Brand	NetCommWireless
Model	NF18ACV
Category	Gateway
Language	English