NetCommWireless NF18ACV User Manual

84 of 131
User Guide
© NetComm Wireless 2017
Parameter
Definition
transmission. The RTS Threshold value should remain at its default value of
2347.
DTIM Interval
(Delivery Traffic Indication Message) Enter a value between 1 and 255 for
the Delivery Traffic Indication Message (DTIM.) A DTIM is a countdown
informing clients of the next window for listening to broadcast and multicast
messages.
Beacon Interval
A beacon is a packet of information that is sent from a connected device to
all other devices where it announces its availability and readiness. A beacon
interval is a period of time (sent with the beacon) before sending the
beacon again. The beacon interval may be adjusted in milliseconds (ms).
Default (100) is recommended.
XPress Technology
Select Enable or Disable. This is a special frame-bursting accelerating
technology for IEEE802.11g. The default is Enabled.
Regulatory Mode
(5 GHz only)
Select: Disabled, 802.11h or 802.11d
The default is Disabled.
Pre-Network Radar
check (5 GHz only)
Available only in the 802.11h Regulatory Mode, see last setting.
The default is: -1
Pre-Network Radar
check (5 GHz only)
Available only in the 802.11h Regulatory Mode, see last setting.
The default is: -1
TPC Migration (db)
(5 GHz only)
Select: 0(off), 2, 3 or 4
The default is 0(off)
WMM (WiFi Multimedia)
Select whether WMM is enable or disabled. Before you disable WMM, you
should understand that all QoS queues or traffic classes relate to wireless do
not take effects.
WMM No
Acknowledgement
Select whether ACK in WMM packet. By default, the 'Ack Policy' for each
access category is set to Disable, meaning that an acknowledge packet is
returned for every packet received. This provides a more reliable
transmission but increases traffic load, which decreases performance. To
disable the acknowledgement can be useful for Voice, for example, where
speed of transmission is important and packet loss is tolerable to a certain
degree.
WMM APSD
APSD is short for automatic power save delivery, selecting enable will make
it has very low power consumption. WMM Power Save is an improvement
to the 802.11e amendment adding advanced power management
functionality to WMM.
Table 31 -Wireless – Advanced configuration settings

NetCommWireless NF18ACV Specifications

General

Brand	NetCommWireless
Model	NF18ACV
Category	Gateway
Language	English