Figure 94 – Wireless - Basic Configuration
The following parameters are available:
Select  Enable Wireless to activate the wireless network function.
Select  to hide the wireless network when an SSID scan is performed.
Select  to prevent clients on the wireless network being able to access
each other.
Select  to prevent the NF18ACV advertising its WMM QoS function
Enable Multicast
Forwarding (WMF)
Wireless Multicast Forwarding can reduce latency and improve
throughput for wireless clients.
Enter the maximum number of wireless clients able to connect to the
wireless network
Wireless Guest / Virtual
Access Points
Select to enable a separate Wireless Guest network.
For each Guest network enter the same options as are available in the top
of this page for the main system wireless network.
Table 29 – Basic Wireless settings table
Click Apply/Save to save the new wireless configuration settings.
Note – Hiding the network may leads to potential connection problems, a non-broadcast network is not undetectable, and hiding a
SSID is Security through obscurity
To Next Page
Loading...
Need help?
General
