6. Below the Service Table, click the Add button.
7. From the Service Type menu, select service or application to be covered by this rule.
If the service or application does not display in the list, you can add it (see Add an Outbound Firewall Rule for
a Custom Service or Application on page 135).
8. Specify which devices on your LAN (or LAN users) are affected by the rule, based on their IP addresses:
• Only This IP Address. Enter the required address in the fields to apply the rule to a single device on your
LAN.
• IP Address Range. Enter the required addresses in the start and end fields to apply the rule to a range of
devices.
• All IP Addresses. All computers and devices on your LAN are covered by this rule.
By default, the All IP Addresses radio button is selected.
9. Click the Add button.
The new rule is added to the Service Table on the Block Services page.
Add an Outbound Firewall Rule for a Custom Service or
Application
The modem router lists many default services and applications that you can use in outbound rules. If the service or
application is not predefined, you can specify a custom service or application in an outbound rule.
To add an outbound firewall rule for a custom service or application:
1. Find out which protocol and port number or range of numbers the service or application uses.
You can usually find this information by contacting the publisher of the service or application or through online
user or news groups.
2. Launch a web browser from a computer or WiFi device that is connected to the network.
3. Enter http://www.routerlogin.net.
Control Access to the Internet
135
Nighthawk AC1900 WiFi VDSL/ADSL Modem Router Model D7000
To Next Page
Loading...
Need help?
General
Weight and Dimensions
