Figure 3. Modem router back panel
In addition to the three antennas, viewed from left to right, the back panel contains the following components:
• LED Off/On switch. Move the LED Off/On switch to to the Off position to turn off all LEDs, except for the
Power LED.
• Reset button. For information about using the Reset button, see Return the Modem Router to Its Factory Default
Settings on page 223.
• Power On/Off button. Press the Power On/Off button to provide power to the modem router.
• DC power connector. Connect the power adapter that came in the product package to the DC power connector.
• Internet port. One Gigabit Ethernet RJ-45 WAN port to connect the modem router to a fiber or cable modem.
This port is colored red.
You can use either the Internet port or the DSL port for WAN connectivity.Note
• Ethernet LAN ports. Four Gigabit Ethernet RJ-45 LAN ports to connect the modem router to LAN devices.
These ports are colored yellow.
• DSL port. One RJ-11 DSL port for connecting the modem router to an ADSL or VDSL line.This port is colored
gray.
Hardware Overview of the Modem Router
16
Nighthawk AC1900 WiFi VDSL/ADSL Modem Router Model D7000