Nidec Control Techniques Digitax-SF Series - Configuring Operating Mode; Position Control; Torque Control; Velocity Control


Digitax SF Instruction Manual
6. Operation
1. Conguring Operating Mode
１. Conguring Operating Mode
The drive
  

Control Mode
（No2.0）
Command Mode
（No.3.0）
Command Input Signal Format
Position Control
（0：Default)
Pulse Train Command（1：Default）
g


󱐯


Internal Speed Command（3）
g

drive
Point table operation


Velocity Control
（1）
Analog Velocity Command（2）
g



Internal Speed Command（3）
g
drive



Torque Control
（2）
Analog Torque Command（2）
g



CAUTION
Before performing wiring to each drive or motor, verify
that all power sources are shut o󱐯.
All wiring work must be performed by certied electricians.
Before applying power to each drive or motor, be
sure that wiring has been performed correctly.