Nidec Control Techniques Digitax-SF Series User Manual


Digitax SF Instruction Manual
6. Operation
5. Position Control Mode
Homing with User I/O Input
Step Operation
Step 1
Set Homing related parameter values

Step 2
Check if Homing can be started.
  
Step 3
Specify the Point Number (in the standard I/O setting only)


Step 4
Start Homing motion


In Standard I/O Setting

Step 3

In Option I/O Setting

Step 3

Step 5
Check Command Execution


Step 6
Check Operation Complete

d
Step 7
Check Homing Complete


Required Parameters
Parameter No. Name Setting
2.0  0
3.0  3
9.0 

0
1Digitax SF Connect
642.0


0

drive


Nidec Control Techniques Digitax-SF Series Specifications

General

Brand	Nidec
Model	Control Techniques Digitax-SF Series
Category	Servo Drives
Language	English