Nidec Control Techniques Digitax-SF Series - If You Start with a Point Number that Is “Disabled”; Valid or Invalid


Digitax SF Instruction Manual
6. Operation
5. Position Control Mode

Valid or Invalid
 
  

This Parameter indicates whether motion per a point number is enabled or disabled.

Disable:


Enable:



If a “disabled” point number is specied while one motion is being executed,


If Dwell time = “0” for a point number assigned “continuous”



W
  
Point No. Running operation Dwell Time Enable/Disable
1   
2   
3   
−
Input
PCSEL1…4
Input
PCSTART1
ON
OFF OFF
0[rpm]
1
Point
No.1
Command
Point
No.3
SignalNameDescription
Chart
Select
PointNo.
Start
Motor
Rotational
Speed
TIP
to be the last motion, set Running Motion = “single”


s
With User I/O
Position error
With Digitax SF Connect
󱐯