Nidec Control Techniques Digitax-SF Series - Auto Tuning on Digitax SF Connect

18
Digitax SF Instruction Manual
7. Tuning
2. Tuning Procedure
Y
N
N
Stage2
Manuallyentertheinertiaratio.
Operation1A
SetControlGainSetto"5"
Entertheinertiaratio
SelecttheTuningtab.
Confirm
Confirm
Set
Set
Operation2
Lettheequipmentsystemmove.
Click
Set
Writetothedrive
Acceptablemotion?
Isthemotorquiet?
Finaltuning
Tuningcomplete
Click
Click
・Checkthemotormotionbytestoperation
orexternalcommandinput.
・Repeatthesystementiremotionseveraltimes.
And/or
Visuallycheck
theactualmotion
:DYHIRUPPRQLWRU
Startingtuningwithalowsetting
ofthecontrollergainsetwillenable
successfultuningwithnovibrations
and lownoise.
Changetheinertiaratio.
Auto Tuning on Digitax SF Connect: Operation 1A