Nidec Control Techniques Digitax-SF Series User Manual


Digitax SF Instruction Manual
Operation
６
6. Operation
5. Position Control Mode
5. Position Control Mode
alignrelative positiondriveparameters actual
mechanical positionthe drive

In incremental systems:

In absolute systems:
y




 



 
 


 
２. Homing
  
Digitax SF Connect 
Digitax SF Connect
Precautions
Homing based on home position sensor front-end
sensor
sensorsensor
sensorsensor

Parameter No.646.1＝０
sensor
Parameter No.646.1=1
sensor
ORGInput
sensor
OFFON
HomingDirection
Mechanicalmotionrange
CW
direction
CCW
direction
sensor
OFF ON
CW
direction
CCW
direction
HomingDirection
Mechanicalmotionrange
ORGInput
If you changed the command paired-pulse ratio value,

If you execute Homing by using encoder Z-phase,



If any of the following occur during the homing motion,


 Position ErrorPosition Error

Limit Switch Input is activePosition Error

Nidec Control Techniques Digitax-SF Series Specifications

General

Brand	Nidec
Model	Control Techniques Digitax-SF Series
Category	Servo Drives
Language	English