Nidec Control Techniques Digitax-SF Series - Page 279


Digitax SF Instruction Manual
6. Operation
5. Position Control Mode
sensor
Position
Origin
Speed
Home
Homereferenceposition
Homing Based on Home Sensor (no sensor re-detection)（No.645.0=2, No.645.3=0）
This operation indicates the type of homing based on the home position sensor.
no detection of the sensor-front-end after the first detection
sensor
sensor
sensorsensor



Group Name Parameter No.



sensor
645.0

 646.0


650.0
 653.0


  646.1
 648.0


 647.1

 645.1

657.0

645.3

649.0

sensor



651.0


 646.3
 647.0
 646.2
n
659.0
Pattern 13
Parameters Settings

No.645.0
2
sensor
No.645.3
0

No.645.1
0

No.647.1
0

No.651.0
0

No.657.0
0