Nidec Control Techniques Digitax-SF Series User Manual


9. Appendices
Digitax SF Instruction Manual
4. Status Display
Status
Analog Velocity Command
Units Bytes Signed
Status No.
（Hexadecimal number）
49 （31）
rpm
 
Description
Indicates the value of the analog speed command being input to the drive.
In Analog Velocity Command mode, by measuring this value (in the waveform data displayed
in Digitax SF Connect) and the value of speed error at the same time, you can check the
command response and vibration.
Transmit data
24 01 00 10 00 31 F2 F9
Status
Positioning Status
Units Bytes Signed
Status No.
（Hexadecimal number）
64 （40）
  
Description



Transmit data
24 01 00 10 00 40 9C 4F
Status
Internal Command Value
Units Bytes Signed
Status No.
（Hexadecimal number）
65 （41）
  
Description
 


Transmit data
24 01 00 11 00 41 BB 5E
Status
Position Feedback
Units Bytes Signed
Status No.
（Hexadecimal number）
67 （43）
  
Description
drive
Transmit data
24 01 00 11 00 43 9B 1C

Nidec Control Techniques Digitax-SF Series Specifications

General

Brand	Nidec
Model	Control Techniques Digitax-SF Series
Category	Servo Drives
Language	English