Nortel BayStack 350 Series - Page 74

Using the BayStack 350 Series 10/100 Autosense Switch
1-36
893-00992-E
Figure 1-24. Trunk Configuration screen for switch SW2
The Inter-Switch Trunk Configuration screen for switch SW2 is configured as
follows:
• Trunk (read only) indicates the trunks (I1 and I2 for this switch) that
corresponds to the switch ports specified in the Trunk Members fields.
• Trunk Members indicates the ports that can be configured, in each row, to
create the corresponding trunk:
-- Ports 25 and 26 are assigned as trunk members of trunk I1.
-- Ports 1 and 2 are assigned as trunk members of trunk I2.
• STP indicates the spanning tree participation setting for each of the trunks:
In this example, trunks I1 and I2 are enabled for spanning tree participation.
Inter-Switch Trunk Configuration
Trunk Trunk Members STP Trunk Mode Trunk Status
----- ---------------------------- ------------ --------------- ------------
I1 [ 25 ][ 26 ][ ][ ] [ Enabled ] [ Enhanced ] [ Enabled ]
I2 [ 1 ][ 2 ][ ][ ] [ Enabled ] [ Enhanced ] [ Enabled ]
I3 [ ][ ] [ Enabled ] [ Enhanced ] [ Disabled ]
I4 [ ][ ] [ Enabled ] [ Enhanced ] [ Disabled ]
Valid inter-switch trunk configurations are:
1 or 2 trunks of up to 4 links each
Up to 4 trunks of 2 links each
Use space bar to display choices, press <Return> or <Enter> to select choice.
Press Ctrl-R to return to previous menu. Press Ctrl-C to return to Main Menu.