[4’] ON position setting by Teaching
Move the machine to the desired ON position, then press the
key. The current position value will then be adopted as the ON
position setting value.
Press the key to enter the OFF position. At this time, the ON
LED begins flashing and the OFF LED is switched ON.
[5] OFF position setting by numeric input.
Enter the OFF position setting value.
[5’] OFF position setting by Teaching
Move the machine to the desired OFF position, then press the
key. The current position value will then be adopted as the
OFF position setting value.
[6] Resister the ON/OFF position settings.
Press the key to register the designated ON/OFF position
settings. At this time, the MULTI display will be changed from “0”
to “1”, and the Dog No.1 ON position setting status will be
established.
To Next Page
Loading...
