Oki MC770 - Page 147

45584901TH Rev.1
5-54 /
Oki Data CONFIDENTIAL
[F109_4] Key consistency error (license data damage)
Classification Contents
Other service call Keyconsistencyerror-Thelicensedataaredamaged.
Check item Measures
Encryption key status
confirmation
Checkthemessagedisplayedby[3]+[C]+[POWER]
→
5.KeyBackup
Restore.
Take measures given in the following table according to the messages displayed in the SRAM
LicenceStatusandFROMLicenceStatuselds.
Remarks:
Iftheerrorisnotcleared,reinstallationofthesystemfirmware,systemsoftwareand
application is needed. ([4]+[9]
→
Power-ON)
SRAMLicence
Status
FROMLicence
Status
Measure
* AccessFailed Replace the CU board.

P. 6-16 "6.2.4 Precautions and Procedures when replacing the CU
board" (all steps)
<WithUSBbackupdata:Allkeydatarecovery>
1. Recover all the data on the SRAM board.
[5]+[9]+[POWER]
→
2. Restore SRAM Data from USB
(Fordetails,see"9.1.4Cloningprocedure[B]Restoreprocedure")
2. Recover the encryption key/license on the CU board.
Follow the procedures below noted in "6.2.4Precautions and
Procedures when replacing the CU board".
[D] Restore ADI key (only when ADI-HDD is installed)
[E] Restore encryption key
[F] Restore license
AccessFailed * Replace the CU board.

P. 6-20 "6.2.5 Precautions and procedure when replacing the
SRAM board (for the CU board)" (all steps)
KeyMismatch KeyMismatch <The error occurs when the CU board is replaced>
RecoverthelicenseontheCUboard.(TransferthelicensefromSYS-
SRAMtoSYS-FROM.)

P. 6-16 "6.2.4 Precautions and Procedures when replacing the CU
board"([F]Restore license)
<The error occurs except when the CU board is replaced>
Recover the license on the SRAM board. (Transfer the license from
SYS-FROMtoSYS-SRAM.)

P. 6-20 "6.2.5 Precautions and procedure when replacing the
SRAM board (for the CU board)"([I]Backup license)
*AccessFailed,orKeyMismatch