EasyManua.ls Logo

Omega DP41-B - Page 64

Omega DP41-B
132 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
14
Reading Configuration Menu
54
Press ‘RESET/ENTER 22) Display shows "xxxxxx" some 6-digit number, represents the value of
"INPUt 1" as taken from live input source measurement for desired value.
Press ‘RESET/ENTER 23)
Display shows "REAd 1" Item #2 of coordinate #1.
Press ‘RESET/ENTER 24) Display shows "xxxxxx" some 6-digit number with first digit flashing,
represents the value of "REAd 1" item #2 of coordinate #1.
Press ‘/MAX & ‘
/MIN 25) Use ‘MAX and ‘MIN buttons to enter new value of "REAd 1".
Press ‘RESET/ENTER 26)
Display shows "INPUt 2" Item #1 of coordinate #2.
Continue to
proceed with the selection and value entry, for "INPUt 1" and "REAd 1"
for "INPUt 2" and "REAd 2", (item #1 and #2 of coordinate #2), similar to
steps above.
Press ‘RESET/ENTER 27)
Display advances to "UNt.tMP" Temperature Unit selection Submenu.
If an item # of coordinate # was prompted or modified, the controller will
also show the "StOREd" stored message momentarily.
MANUAL
Press ‘RESET/ENTER 28) "MANUAL" heading stops flashing.
Press ‘RESET/ENTER 29)
Display shows "INPUt 1" Item #1 of coordinate #1.
Pressing ‘RESET/ENTER’ to sequence through:
"INPUt 1", Input 1 ’s value
"REAd 1", Read 1 ’s value
"INPUt 2", Input 2 ’s value
"REAd 2", Read 2 ’s value
headings for the desired selection and continue using ‘MAX and ‘MIN
buttons to manually enter or modify the values as described in the
following section.
Press ‘RESET/ENTER 30) Display shows "xxxxxx" some 6-digit number with first digit flashing,
represents the value of "INPUt" item #1 of coordinate #1.
Press ‘/MAX & ‘
/MIN 31) Use ‘MAX and ‘MIN buttons to enter new value of "INPUt 1" item #1
of coordinate #1.
Press ‘RESET/ENTER 32) Display shows "REAd 1". Continue the sequential items with ‘MAX &
MIN buttons to select and enter values.
Press ‘RESET/ENTER 33)
Display advances to "UNt.tMP" Temperature Unit selection Submenu. If
an item # of coordinate # was prompted or modified, the controller will also
show the "StOREd" stored message momentarily.

Table of Contents

Other manuals for Omega DP41-B

Related product manuals