Omron CP1L - Page 138

104
Mounting Section 3-3
DIN Track Installation The CP1L CPU Unit, Expansion Units, and Expansion I/O Units can be
mounted to DIN Track. Secure the DIN Track with screws in at least three
places.
Using I/O Connecting
Cable
When using Expansion Units and Expansion I/O Units, it is possible to use
CP1W-CN811 Connecting Cable to arrange the Units in upper and lower
rows. The following restrictions apply:
• I/O Connecting Cable can be used in one place only, and not in multiple
places.
Wiring Ducts Whenever possible, route I/O wiring through wiring ducts. Install the duct so
that it is easy to wire from the I/O Units through the duct. It is handy to have
the duct at the same height as the PLC.
Note Tighten terminal block screws and cable screws to the following torque.
M4: 1.2 N·m
M3: 0.5 N·m
DIN Track
SYSMAC
CP1L
L1 L2/N COM010305070911010305070911
00 02 04 06 08 10 00 02 04 06 08
10
00 01 02 03 04 06 00 01 03 04 06
COM COM COM COM 05 07 COM 02 COM 05
07
IN
OUT
CH
NC
NC
NC
NC
NC
NC
COM
COM COM COM COM COM COM03 06 01 03 06
00 02 04 06 08 10
00 01 02 04 05 07 00 02 04 05 07
00 02 04 06 08 10
01 03 05 07 09 11 01 03 05 07 09 11
IN
40EDR
OUT
CH CH
CH CH
EXP
CH
CH
CH
111009080706050403020100
111009080706050403020100
0706050403020100
0706050403020100
CH
NC
NC
NC
NC
NC
NC
COM
COM COM COM COM COM COM03 06 01 03 06
00 02 04 06 08 10
00 01 02 04 05 07 00 02 04 05 07
00 02 04 06 08 10
01 03 05 07 09 11 01 03 05 07 09 11
IN
40EDR
OUT
CH CH
CH CH
EXP
CH
CH
CH
111009080706050403020100
111009080706050403020100
0706050403020100
0706050403020100
CH
NC
NC
NC
NC
NC
NC
COM
COM COM COM COM COM COM03 06 01 03 06
00 02 04 06 08 10
00 01 02 04 05 07 00 02 04 05 07
00 02 04 06 08 10
01 03 05 07 09 11 01 03 05 07 09 11
IN
40EDR
OUT
CH CH
CH CH
EXP
CH
CH
CH
111009080706050403020100
111009080706050403020100
0706050403020100
0706050403020100
20 mm min.
20 mm min.
40 mm
30 mm
30 mm
81.6 to 89.0 mm
Duct
Unit
Duct
DIN Track
Duct
CPU
Rack
Mounting
bracket