Omron CP1L - Page 686

652
Auxiliary Area Allocations by Address Appendix D
A526 A526.00 Serial Port 2
Restart Bit
(CP1L M-
type CPU
Units)
Turn this bit ON to restart the serial
port 2 of a CP1L M-type CPU Unit.
(Do not use this bit when the port is
operating in Peripheral Bus Mode.)
Note This bit is turned OFF auto-
matically when the restart
processing is completed.
OFF to ON:
Restart
Retained Cleared --- ---
Serial Port 1
Restart Bit
(CP1L L-
type CPU
Units)
Turn this bit ON to restart the serial
port 1 of a CP1L L-type CPU Unit.
(Do not use this bit when the port is
operating in Peripheral Bus Mode.)
Note This bit is turned OFF auto-
matically when the restart
processing is completed.
A526.01 Serial Port 1
Restart Bit
(CP1L M-
type CPU
Units)
Turn this bit ON to restart the serial
port 1 of a CP1L M-type CPU Unit.
Note This bit is turned OFF auto-
matically when the restart
processing is completed.
0 to ON:
Restart
Retained Cleared --- ---
A527 A527.00
to
A527.07
Online Edit-
ing Disable
Bit Validator
The Online Editing Disable Bit
(A527.09) is valid only when this byte
contains 5A.
To disable online editing from the
CX-Programmer, set this byte to 5A
and turn ON A527.09.
(Online editing refers to changing or
adding to the program while the PLC
is operating in MONITOR mode.)
5A:
A527.09
enabled
Other value:
A527.09 dis-
abled
Retained Cleared --- A527.09
A527.09 Online Edit-
ing Disable
Bit
Turn this bit ON to disable online
editing. The setting of this bit is valid
only when A527.00 to A527.07 have
been set to 5A.
ON: Disabled
OFF: Not dis-
abled
Retained Cleared --- A527.00
to
A527.07
Addresses Name Function Settings Status
after
mode
change
Status at
startup
Write
timing
Related
Flags,
Settings
Word Bits