Omron CX-PROGRAMMER V9 - Ok Ok Ok

CX-Programmer_Page (xx)
Functions Supported by Unit Version 3.0 or Later
CS1-H CPU Units (CS1@-CPU@@H)
Unit version Function
Pre-Ver. 2.0, Ver.
2.0
Ver. 3.0 Ver. 4.0
(See note.)
Function blocks (supported for CX-Programmer Ver.
5.0 or higher)
--- OK OK
Serial Gateway (converting FINS commands to
CompoWay/F commands at the built-in serial port)
--- OK OK
Comment memory (in internal flash memory) --- OK OK
Expanded simple backup data --- OK OK
TXDU(256), RXDU(255) (support
no-protocol communications with
Serial Communications Units with
unit version 1.2 or later)
--- OK OK
Model conversion instructions:
XFERC(565), DISTC(566),
COLLC(567), MOVBC(568),
BCNTC(621)
--- OK OK
New
application
instructions
Special function block instructions:
GETID(286)
--- OK OK
Additional
instruction
functions
TXD(235) and RXD(236)
instructions (support no-protocol
communications with Serial
Communications Boards with unit
version 1.2 or later)
--- OK OK
New
application
instructions
ASCII conversion instructions
(NUMBER-TO-ASCII and ASCII-
TO- NUMBER)
Text File Write (TWRIT)
--- --- OK
Online editing of function blocks --- --- OK
Input-output variables are
supported.
(Input-output variables can be
specified in arrays.)
--- --- OK
Improved
function block
(FB) functions
The STRING data type and text-
string processing functions are
supported in ST language.
--- --- OK
Using ST language programming in tasks --- --- OK with CX-
Programmer Ver. 7.2
or higher
Using SFC programming in tasks --- --- OK with CX-
Programmer Ver. 7.2
or higher
Note: CX-Programmer version 7.0 or higher is required to use functions added for unit version
4.0. Additional functions are supported if CX-Programmer version 7.2 or higher is used.
CS1D CPU Units
Unit version 3.0 (Ver. 3.0) is not supported.