PART 2: CX-Server PLC Tools
CHAPTER 10 – Data Links OMRON
CX-Server PLC Tools_Page 120
Connecting Online
After the PLC has been registered, select either of the following types of registered PLCs for connecting online,
depending on the CX-Net function used.
1) PLCs registered for direct connection
2) PLCs registered as nodes on a network
PLC registered for online connection
CX-Net function
(1) PLC registered for direct
connection (node
address 0)
(2) PLC registered as node on a
network (node address 01 or
higher)
Controller Link Not supported. (See note.) Supported
SYSMAC LINK Not supported. (See note.) Supported
Data link table
transfer
SYSMAC NET Supported Not supported.
Note: If there is a routing table, node address 0 is possible.
When transferring Controller Link or SYSMAC LINK data link tables, therefore, online connection is required
for PLCs registered as nodes on a network.
Example: Connecting PLC1 (Registered as a Node on a Network) Online
1 In the CX-Net project workspace, select the PLC to be connected online.
2 In the project workspace, select PLC1, and then select Open from the PLC menu.
PLC1 will be connected online, and the display will change as follows:
Changes to green when online.
The online/offline status and the
PLC’s operation mode are displayed.
Select PLC1, and
then select
Open
from the
PLC
menu.
To go back offline, again select Open from the PLC menu.
To Next Page
Loading...
Need help?
General