Omron CX-PROGRAMMER V9 - Default SYSMAC Support Soft Keyboard Mapping

PART 1: CX-Programmer
Keyboard Shortcuts − CX-Programmer OMRON
CX-Programmer _Page 130
Transfer to PLC [PLC] | [Transfer] | [To PLC...] [Ctrl]+[T]
Transfer from PLC [PLC] | [Transfer] | [From PLC...] [Ctrl]+[Shift]+[T]
Force on [PLC] | [Force] | [On] [Ctrl]+[J]
Force off [PLC] | [Force] | [Off] [Ctrl]+[K]
Cancel force [PLC] | [Force] | [Cancel] [Ctrl]+[L]
Begin on-line edit [Programs] | [Online Edit] | [Begin] [Ctrl]+[E]
Send on-line edit changes [Programs] | [Online Edit] | [Send Changes] [Ctrl]+[Shift]+[E]
Cancel on-line edit [Programs] | [Online Edit] | [Cancel] [Ctrl]+[U]
Smart Input Mode
Program Editing
Input item Smart Input Mode Classic Mode
Insert Open Contact L (LD), A (AND) C C
Insert Closed Contact L (LDNOT ) A (ANDNOT) / /
Insert Open Contact OR O (OR) W W
Insert Closed Contact OR O (ORNOT) X X
Insert Open Coil O (OUT) O O
Insert Closed Coil O (OUTNOT) Q Q
Insert Rung Below Press “R” and select Insert Rung Below. R
Insert vertical connecting line above Shift+U U
Insert vertical connecting line below Shift+V V
Insert horizontal connecting line Shift+H H
Differentiate Up @ Not supported.
Differentiate Down % Not supported.
Immediate Refreshing ! Not supported.
Clear Differentiation Shift+0 Not supported.
Shortcut Keys That Differ from Classic Mode
Action Smart Input Mode Classic Mode
Edit Rung Comment Shift+L L
Go to error Shift+J J
Go to Next Address Reference Shift+N N
Go to Previous Jump Point Shift+B B
Default SYSMAC Support Soft Keyboard Mapping
Basic operations
Shortcuts for all functions except for the following are the same as the defaults for the CX-Programmer.
Function
Menu Shortcut keys
View project workspace [View] | [Window] | [Workspace] [Ctrl]+[F11], [Alt]+[1]
View Output window [View] | [Window] | [Output] [Ctrl]+[F12], [Alt]+[2]
View Watch window [View] | [Window] | [Watch] [Ctrl]+[F10], [Alt]+[3]
View Address Reference Tool [View] | [Window] | [Address Reference
Tool]
[Shift]+[F12], [Alt]+[4]
Show Rung Annotations [View] | [Show Rung Annotations] [Alt]+[F8], [Alt]+[A]
Show Symbol Comments [View] | [Show Symbol Comments] [Alt]+[F9], [Alt]+[Y]
Undo [Edit] | [Undo] [Ctrl]+[F3], [Alt]+[F11], [Ctrl]+[Z]
Redo [Edit] | [Redo] [F3], [Ctrl]+[Y]