Omron CX-PROGRAMMER V9 User Manual

PART 2: CX-Server PLC Tools
CHAPTER 10 – Data Links OMRON
CX-Server PLC Tools_Page 98
Creating Data Link Tables
Create a data link table for each node registered in the CX-Server file that is read.
Make the settings for (1) to (8) below.
Node 2
(receive)
(3)
Area setting
(area/start
address
)
(4) Send size
(2) Node 1
PLC type
Node 1
(send)
Node 3
(receive)
(7) Receive
sizes from
remote nodes
(5) Node refresh sequence
:
2, 1, 3 1, 2, 3 2, 1, 3
(6)
Status area
Node 3
(receive)
Node 3
(send)
Node 2
(send)
Node 1
(receive)
Node 1
(receive)
Node 2
(
receive
)
Data link
status
Data link
status
Data link
status
Node 2
PLC
Node 3
PLC
(8)
Offsets
(1) Participating data link nodes
To create a data link table, make the following settings in order.
1 Datalink Wizard Settings
(1) Set participating data link nodes.
(2) Set the PLC type.
(3) Set the areas.
(6) Set the status area.
(5) Set the refresh node sequence.
(4) Set the send size.
2 Node Editing Window Settings
(7) Set receive sizes from remote nodes.
(8) Set offsets.

Omron CX-PROGRAMMER V9 Specifications

General

Brand	Omron
Model	CX-PROGRAMMER V9
Category	Software
Language	English