PART 2: CX-Server PLC Tools
OMRON CHAPTER 3 – IO Table Component
CX-Server PLC Tools_ Page 23
When Units which do not have CPS are registered in the I/O tables, the current
consumption and width cannot be calculated correctly. In this case, estimated values
marked with "*" are displayed for the current consumption and width as shown below.
Specifically, when a previous model of a Unit (such as C200H I/O Units) is used,
estimated values may be displayed.
In this case, check the current consumption and width in the Operation Manual of the
Unit.
Online, the current status of the DIP switches on the target PLC (CPU Unit) can be
checked by selecting Options - DipSwitch Information.
Displaying the C/CV I/O Table Window
The C/CV I/O Table Window is displayed when the PLC is not a CS/CJ/CP-series PLC.
Rack’s starting CIO address
Slot number
Rack number
Unit’s starting CIO address
Unit name
Number of output words and
number of input words
Special I/O
Unit’s unit
number
Unit Settings
Settings for the CS/CJ/CP I/O Table Window
The CS/CJ/CP I/O Table Window is displayed when the PLC is a CS/CJ/CP-series PLC.
Creating an IO Table
Creation of an IO Table whilst connected to a PLC causes the Actual IO Table in the hardware to be written to the
Registered IO Table. An IO Table can also be edited offline and stored to file, this method is usually employed
when designing a PLC’s IO Table.
To create an IO Table, select Create from the Options menu.
Slot Allocation
The following procedure shows how to edit the I/O table in the I/O Table Window.
To Next Page
Loading...
Need help?
General