PART 2: CX-Server PLC Tools
OMRON CHAPTER 3 – IO Table Component
CX-Server PLC Tools_ Page 33
Starting Specialized Support Tools
Starting Specialized Programming Support Tools (Supported When Support Tools Were Installed from CX-One)
When the CX-Programmer and other Programming Support Tools have been installed from the CX-One, the
Programming Support Tool specific to a particular Unit (Special I/O Unit or CPU Bus Unit) can be started directly
from the CS/CJ/CP I/O Table Window by right-clicking the desired Unit in the I/O table and selecting Start
Special Application from the pop-up menu.
♦ If the Unit is right-clicked in the I/O table and Start Special Application - Start with Settings Inherited is
selected, the PLC model information, Unit model, and online/offline status information will be passed to the
Programming Support Tool automatically when it starts.
♦ If the Unit is right-clicked in the I/O table and Start Special Application - Start Only is selected, the
Programming Support Tool will be started in the same way as it is from the Windows Start Menu.
The following diagram shows how each Programming Tool can be started and how the I/O Table Window can be
opened from the Programming Tool.
To Next Page
Loading...
Need help?
General