Omron MX2 Series User Manual

1 Overview
1 - 31
Multi-function Compact Inverter 3G3MX2-EV2 User’s Manual (I666-E1)
Parameter No.
Function name
P211 to P220
Modbus Mapping
External Register Type 1 to 10
P221 to P230
Modbus Mapping
Scaling 1 to 10
P301 to P310
Modbus Mapping
Internal Register 1 to 10
P400
Modbus Mapping
Endian Selection
The 3G3MX2-EV2 Series Inverter allows you to overwrite the following parameters at any time during
RUN, although the 3G3MX2-E Series Inverter does not allow it unless you select “Data can be
changed during RUN.” If necessary, configure change prohibition settings by using soft lock and pass-
word protection functions. Refer to 7-6-1 Soft Lock Function (SFT) on page 7-54 and 7-6-9 Password
Function on page 7-57.
Parameter No.
Function name
A011
O Start Frequency
A012
O End Frequency
A013
O Start Ratio
A014
O End Ratio
A015
O Start Selection
A016
Analog Input Filter
A039
Jogging Stop Selection
A051
DC Injection Braking Selection
A052
DC Injection Braking Frequency
A053
DC Injection Braking Delay Time
A054
DC Injection Braking Power
A055
DC Injection Braking Time
A056
DC Injection Braking Edge/Level Selection
A057
Startup DC Injection Braking Power
A058
Startup DC Injection Braking Time
A059
DC Injection Braking Carrier Frequency
A061
1st Frequency Upper Limit
A261
2nd Frequency Upper Limit
A062
1st Frequency Lower Limit
A262
2nd Frequency Lower Limit
A063
Jump Frequency 1
A064
Jump Frequency Width 1
A065
Jump Frequency 2
A066
Jump Frequency Width 2
A067
Jump Frequency 3
A068
Jump Frequency Width 3
A069
Acceleration Stop Frequency
A070
Acceleration Stop Time
A071
PID Selection
A075
PID Scale
A076
PID Feedback Selection
A077
PID Deviation Reverse Output
A078
PID Variable Range Limit
A079
PID Feedforward Selection
A083
AVR Filter Time Constant
A084
AVR Gain at Deceleration
A101
OI Start Frequency
1
1-5 Comparison with Previous
Model

Omron MX2 Series Specifications

General

Cooling Method	Fan cooling
Output Frequency Range	0.1 to 400 Hz
Control Method	V/f control, Sensorless vector control
Protection Functions	Overcurrent, overvoltage, undervoltage, overload, overheating, short circuit
Communication Options	Modbus RTU
Overload Capacity	150% for 60 seconds
Braking Unit	Built-in
Ambient Operating Temperature	-10°C to +50°C
Enclosure	IP20
Storage Temperature	-20°C to +65°C
Humidity	5 to 95% RH (non-condensing)
Altitude	Up to 1000m
Power Supply Voltage	200-240V AC
Input Voltage	3-phase 200-240V AC