429
Data Break (Command)
The
read information is specified one item at a time separated by a break code
(,).
The maximum number of items that can be specified is 128. (When the PV of
a
timer/counter is specified, however
, the status of the Completion Flag is also
returned, and must therefore be counted as two items.)
Batch Reading
The
bit, word, and timer/counter status
is read as a batch according to the read
information that was registered with QQ.
Command Format
@ QQ
x
10
0
x 10
1
IR
↵:
Node no.
Header
code
Sub-header
code
TerminatorFCS
Response Format
,
@
QQ
x
10
0
x 10
1
x 16
1
x 16
0
IR
x 16
3
x 16
2
x 16
1
x 16
0
↵:
ON/
OFF
x 10
3
x 10
2
x 10
1
x 10
0
ON/
OFF
Node no.
Header
code
Sub-header
code
End code
Timer/Counter
If PV is specified the sta
-
tus of the Completion Flag
is also returned.
Data break
Bit data
ON/OFF
W
ord data
IR, SR, LR, HR,
AR, DM
TerminatorFCS
,,
,
Parameters Read Data (Response)
Read
data is returned according to the data
format and the order in which read
information
was registered using QQ. If “Completion Flag” has been specified,
then
bit data (ON or OFF) is returned. If “W
ord” has been specified, then word
data is returned. If “PV” has
been specified for timers/counters, however
, then
the PV is returned following the Completion Flag.
Data Break (Response)
The break code (, ) is returned between sections that are read.
11-3-34 ABORT –– XZ
Aborts the Host Link operation that is currently being processed, and then en-
ables
reception of the next command.
The ABOR
T command does not receive a
response.
Command Format
@ XZ
x
10
0
x 10
1
↵:
Node no.
Header
code
TerminatorFCS
Host Link Commands
Section 11-3
To Next Page
Loading...
Need help?
General
