Page 5-4
1B4C-003P
1B4C-002P
1E4C-E-OMA05-A01-00
Procedure for SP28P-D/DU
• Set the mask that fits the board.
1. Turn OFF the servo switch.
2. Open the front safety cover.
3. Rotate the mechanical valve for mask
frame holder counterclockwise.
• Now that the mask can be set.
4. Set the mask.
∗ Check the pattern so that the inner and the
front side of mask will not be confused.
5. Pull back the mask until it touches the
stopper at the right front side.
6. Rotate the mechanical valve for mask
frame holder clockwise.
To the next page
OFF ( )
ON ( )
SERVO
Stopper
How to Set Mask
1B4C-004P
1B4C-005P
To Next Page
Loading...
