Page 3-4
Menu Configuration
Describes returning all axes
to their origins.
Describes checking production
motion and breaking in solder.
Describes opening, closing
and retracting squeegee.
Describes maintaining recognition
device and checking its motion.
3-4-1
3-4-4
3-4-5
3-4-12
3-4-13
3-4-14
3-4-2
Describes adjusting the width
of conveyor.
Describes correcting board
recognition coordinates.
Describes checking printing motion.
Describes checking mask
cleaning motion.
Describes correcting mask
recognition coordinates.
Describes checking the motion
of solder autofeeding unit.
Describes displaying the state
of machine in address.
Describes displaying the state
of valve in address.
Describes displaying the
information of all axes.
3-4-6
3-4-7
3-4-10
3-4-11
3-4-8
3-4-9
Machine
adjust
Machine
config
Describes setting the conditions
for the motions for adjustment.
3-5-1
3-5-3
3-5-2
Describes setting the time of
the machine.
Describes displaying the latest
100 recognition results.
Describes setting and display-
ing the value of conditions for
feedback range.
3-5-5
Describes displaying the past
feedback results.
Describes customizing the
functions to use them in the
operator mode.
3-5-6
3-5-4
Returning to Origin
Width Adjustment
Board Recognition
Mask Cleaning
Mask Recognition
Solder Feeding
Trial Printing
Input Check
Output Check
Axis Information
Recognition Device Maintenance
Printing Motion
Squeeze Open/Close
Switch for Adjustment
Setting Time
Feedback Range
Feedback History
Customizing Operator Mode
Collecting Recognition Result
3-4-3
Describes transporting board
onto conveyor.
Board Transport
1E4C-E-OMA03-A01-00
To Next Page
Loading...
