Panasonic SP28P - How to Change Password

Page 2-13
BASIC OPERATION
2
2-4-2 How to Change Password
∗ To change (set) the password, you need the key floppy disk for changing password.
1. Insert the key floppy disk for chang-
ing password into the floppy disk
drive.
2. Press
Engineer
on the main menu in the
operator mode.
3. Press Password change .
4. Enter a new password, then press
Decision .
5. Enter the new password again, then
press Decision .
• When the password entered at the step 4 is the
same as the one entered at the step 5, it is
changed and the main menu of operator mode
is displayed.
6. Press
Engineer
, and make sure you can
enter engineer mode with the new
password.
• If you cannot enter engineer mode, perform
this procedure from step 3 again.
7. Take out the key floppy disk from the
floppy disk drive.
Engineer Mode
1E4C-E-OMA02-A01-01
2
1
3