Page 6-1
File operation
This chapter describes the production data file operation such as how to save cre-
ated production data and how to load the production data saved in each device (PT,
hard disk and floppy disk).
When the following switches are displayed, the highlighted one is the cur-
rently selected device.
Each function to be used for file operation is classified into one of two types:
a main operation or a sub operation.
• Main operation
Used to load/save data and so on.
• Sub operation
Used to delete data, initialize floppy disk, load coordinates data/recognition data
and so on.
∗ For how to send data from PT to this machine, refer to “PT Programming Manual”
that accompanies PT.
1E4C-E-OMA06-A01-01
Chapter 6
FILE OPERATION
• Switches the current device to the floppy disk.
(Be sure to use 2DD floppy disk.)
• Switches the current device to the hard disk.
(This is displayed and used for PT-less specification only.)
• Switches the current device to PT.
(This is displayed and used for PT specification only.)
Device select
PT
Floppy disk
Hard disk
To Next Page
Loading...
