Input
11 - 11
END
● By pressing the corresponding +/- key set the stitch length for the roller presser at
"2.5 ".
● By pressing the corresponding +/- key set the stitch length for the feed wheel at "2.5".
● By pressing the stitch count key, switch on the corresponding function.
The display changes for the input of the number of stitches.
● If the stitch count function is already switched on, change by pressing the Scroll key.
● By pressing the corresponding +/- key select "NO" to add further seam sections.
● By pressing "+" on the corresponding +/- key change to the second seam section.
In the second seam section
- the stitch length (for roller presser and feed wheel) should be 2.5 mm
- and a stitch count should be carried out (1 stitch).
● By pressing the Scroll key, select the following display on the screen.
2
21
PM
● By pressing the corresponding +/- key set the number of stitches at "1".
2
2 2.5 2.5
PM
1 END
1 INS DEL NO
PM
To Next Page
Loading...
