Input
11 - 12
● By pressing "+" on the corresponding +/- key change to the third seam section.
In the third seam section
- the stitch length (for roller presser and feed wheel) should be 3 mm
- a stitch count should be carried out (2 stitches),
- and the seam should be sewn in reverse.
● By pressing the corresponding +/- key set the stitch length for the roller presser
at "3.0 ".
● By pressing the corresponding +/- key set the stitch length for the feed wheel at "3.0".
● By pressing the stitch count key, switch on the corresponding function.
The display changes for the input of the number of stitches.
● If the stitch count function is already switched on, change by pressing the Scroll key.
3
32
PM
● By pressing the corresponding +/- key set the number of stitches at "2".
● By pressing the corresponding key, switch on the reverse sewing function.
● By pressing "+" on the corresponding +/- key change to the fourth seam section.
3
3 3.0 3.0
PM
To Next Page
Loading...
