Pfaff 1571 - Page 66

Input
11 - 13
● By pressing the corresponding +/- key set the stitch length for the roller presser
at "5.0 ".
● By pressing the corresponding +/- key set the stitch length for the feed wheel at "5.0".
● By pressing the stitch count key, switch on the corresponding function.
The display changes for the input of the number of stitches.
● If the stitch count function is already switched on, change by pressing the Scroll key.
In the fourth seam section
- the stitch length (for roller presser and feed wheel) should be 5 mm
- a stitch count should be carried out (1 stitch).
● By pressing the corresponding +/- key set the number of stitches at "1".
●● By pressing "+" on the corresponding +/- key change to the fifth seam section.
4
41
PM
4
4 5.0 5.0
PM