TROUBLESHOOTING : ERROR MESSAGES
02.9687.0010 0 15
2
Troubleshooting
Error Messages
If a problem occurs during luminaire calibration, at the end of the calibration sequence the Menu
Display will cycle through any applicable error message(s), one at a time until the end of the list is
reached. To review the error messages again, it will be necessary to access them using the Status
function. (Refer to “Troubleshooting Guide” on page 16 for a list of possible causes and remedies
associated with the error messages.)
To access error messages:
Step 1. Press [Menu].
Step 2. Press [Up] / [Down] arrows until Fixture appears. Press [Enter].
Step 3. Press [Up]/ [Down] arrows to access Status. Press [Enter]. (Display will now scroll
through any error messages or display OK if no errors.)
WARNING: As with any repairs or maintenance to VARI❋LITE luminaires, service should only be
performed by a trained and qualified service technician or at an Authorized VARI❋LITE
Service
Center.
Display Message
OK No Errors Found
Pan/Encoder/Fail Pan encoder failure.
Tilt/No Sens Tilt sensor not found.
Tilt/Encoder/Fail Tilt encoder failure.
Index/No Sens Gobo Index sensor not found.
RotGobo/No Sens Rotating Gobo wheel sensor not found.
FixGobo/No Sens Fixed Gobo wheel sensor not found.
Dimmer/No Sens Dimmer sensor not found.
Cyan/No Sens Cyan sensor not found.
Yellow/No Sens Yellow sensor not found.
Magenta/No Sens Magenta sensor not found.
ColWheel/No Sens Color wheel sensor not found.
Zoom/No Sens Zoom sensor not found.
Edge/No Sens Edge sensor not found.
To Next Page
Loading...
