MAINTENANCE PROCEDURES : ROTATING GOBO WHEEL REPLACEMENT
02.9687.0010 0 55
2
Rotating Gobo Wheel Replacement
WARNING: Ensure that power is completely removed (disconnected) from luminaire before
attempting any work. Wear protection on hands (soft cotton gloves) when handling glass.
To remove the rotating gobo wheel assembly:
Step 1. Remove gobo module assembly from luminaire as described in “Gobo Module Assembly
Removal” on page 23.
Step 2. Remove the fixed color wheel assembly from gobo module assembly as described in “Fixed
Color Wheel Replacement” on page 54.
Note: Cone Set Screw has Loctite 242 and may require small amount of heat to loosen.
Step 3. Using 1/16" Allen driver, loosen cone set screw attaching rotating gobo wheel to drive shaft.
Figure 2-39: Rotating Gobo Wheel
Rotating Gobo Wheel
Fixed Color Wheel
Fixed Gobo Wheel
Rotating Gobo
Wheel Hub
Hub Cone
Set Screw
NOTE:
Components removed and
exploded for clarity.
See Detail
To Next Page
Loading...
