MAINTENANCE PROCEDURES : PAN BELT REPLACEMENT
02.9687.0010 0 71
2
Pan Belt Replacement
WARNING: Ensure that power is completely removed (disconnected) from luminaire before
attempting any work.
To remove the pan belt:
Step 1. Ensure power is completely removed from luminaire and luminaire has cooled completely.
Step 2. Remove Ballast / LVS assembly as described in “Ballast / LVS Assembly Replacement” on
page 60.
WARNING: Do not set head on or damage front lens during next step!
Step 3. Carefully, flip luminaire to access bottom of enclosure. Do not set on lens.
Step 4. Remove six 1/4-20 x 1/2" PFZ screws and remove Bottom Plate from enclosure assembly.
Figure 2-55: Enclosure Assembly Bottom Plate Removal
Step 5. Remove pan motor assembly as described in “Pan Motor Assembly Replacement” on
page 69.
NOTE:
Components removed and
exploded for clarity.
Enclosure Assembly
1/4-20 x 1/2" PFZ Screw (x6)
Bottom Plate
To Next Page
Loading...
