VARI❋LITE - VL440 / VL770 / VL880 SPOT LUMINAIRES SERVICE MANUAL
56 02.9687.0010 0
Step 4. To install, align drive rear motor homing plate so tab is in optical sensor.
Step 5. Apply Loctite 242 on Cone set screw.
Step 6. Center open spot of wheel to gate and tighten set screw to flat motor shaft.
CAUTION: During reassembly, the alignment of the rotating gobo wheel assembly (alignment drive
rear motor homing plate tab in the optical sensor) is very critical for index to calibrate correctly.
IMPORTANT! When replacing Rotating Gobo Motor, ensure the rear homing plate is installed with
the set screw to the flat part of motor shaft when tab is in sensor. When replacing Index Motor, ensure
the Index Outdrive is installed with set screw to flat part of motor shaft.
To Next Page
Loading...
