MAINTENANCE PROCEDURES : TILT STABILIZER REMOVAL
02.9687.0010 0 39
2
Step 4. Remove Yoke Filler by removing two 6-32 x 3/16" PPB screws and one 8-32 x 3/8" PPB
SEMS screw mounting tilt stabilizer to yoke filler.
Figure 2-22: Yoke Filler Removal
Step 5. Remove four 8-32 x 3/8" PFZ screws securing each tilt bearing to yoke.
Step 6. Cut any cable ties to give enough wiring slack to lift head from yoke
Step 7. At Right Tilt Bearing Assembly, disconnect extension spring from stabilizer and pass
stabilizer around wiring and tilt bearing.
Figure 2-23: Tilt Stabilizer
Step 8. Reassemble following steps in reverse order.
6-32 x 3/16" PPB Screw (x2)
Yoke Filler
NOTE:
Components removed and exploded for clarity.
NOTE:
Components removed and exploded for clarity.
Tilt Stabilizer
Extension Spring
To Next Page
Loading...
