MAINTENANCE PROCEDURES : LAMP SOCKET REMOVAL
02.9687.0010 0 43
2
Step 7. Loosen two quarter-turn Dzus rapier fasteners from lamp house cover and remove lamp.
Figure 2-27: Lamp Socket Cover Removal
Step 8. Remove one 6-32 x 3/8" PPZ SEMS screw and flat washer and detach lamp cover tether
from fixture.
Step 9. As shown in Figure 2-28 on page 44, at each side:
a. Remove two 8-32 x 5/8" PPZ SEMS screw (1 per side) at counter weight plate, closest
to rear of assembly.
b. Note, the counter weight plates will stay attached by 2 screws closest to inside of fixture.
Step 10. Remove two 6-32 x 3/8" PPZ SEMS screws from rear of assembly, closest to L1 & L2 fans.
Lamp Socket
Lamp
Cover
Lamp Socket
Quarter-Turn
Fasteners
To Next Page
Loading...
