Point Grey Flea3 FL3-U3 - Page 4

Point Grey Flea3 USB 3.0 Technical Reference
2.4 Controlling the Camera 25
2.4.1 Using FlyCapture 25
2.4.2 Using Control and Status Registers 25
2.4.2.1 Modes 25
2.4.2.2 Values 26
2.4.2.3 Using the Inquiry Registers 26
2.4.2.4 Using the Absolute Value Registers 26
2.5 Configuring Camera Setup 27
2.5.1 Configuring Camera Drivers 27
2.5.2 Maximum Number of Cameras on a Single Bus 27
3 General Camera Operation 29
3.1 Powering the Camera 29
3.1.1 CAMERA_POWER: 610h 29
3.2 Device Information 29
3.2.1 SERIAL_NUMBER: 1F20h 30
3.2.2 MAIN_BOARD_INFO: 1F24h 30
3.2.3 SENSOR_BOARD_INFO: 1F28h 31
3.2.4 VOLTAGE: 1A50h – 1A54h 31
3.2.5 CURRENT: 1A58h – 1A5Ch 31
3.2.6 TEMPERATURE: 82Ch 32
3.2.7 PIXEL_CLOCK_FREQ: 1AF0h 32
3.2.8 HORIZONTAL_LINE_FREQ: 1AF4h 32
3.3 User Memory Channels 32
3.3.1 MEMORY_SAVE: 618h 33
3.3.2 MEM_SAVE_CH: 620h 33
3.3.3 CUR_MEM_CH: 624h 33
3.3.4 Memory Channel Registers 33
3.4 On-Camera Frame Buffer 35
3.4.1 IMAGE_RETRANSMIT: 634h 36
3.4.2 Example: Retransmitting in Image External Mode Using Registers 36
3.4.3 Example: Storing Images for Later Transmission Using Registers 37
3.5 Non-Volatile Flash Memory 38
3.5.1 DATA_FLASH_CTRL: 1240h 38
3.5.2 DATA_FLASH_DATA: 1244h 38
3.6 Camera Firmware 39
3.6.1 Determining Firmware Version 39
3.6.2 Upgrading Camera Firmware 39
3.6.3 FIRMWARE_VERSION: 1F60h 39
Revised 9/27/2012
Copyright ©2011-2012 Point Grey Research Inc.