ENGINE
2.38
Disassembly, Cont.
22. Remove snap rings and crankshaft seals.
23. Clean thoroughly to remove all grease, oil, dirt, and
old sealant.
Assembly
1. Clean all parts with solvent and dry with
compressed air.
2. Apply 3-Bond¥ 1215 sealant to upper crankcase
half.
NOTE: Use only 3-Bond¥ 1215 sealant. Curing time
and film thickness are critical for proper bearing clear-
ance.
3. Set crankshaft in lower crankcase. Lubricate seal
lips with Premium All Season Grease. Make sure
seals are positioned properly with lip and spring
facing inward toward crankshaft. Install snap rings
with gap facing upward toward upper case half.
3-Bond ¥ 1215
PN 2871557 120 Gram Tube
Enfocus Software - Customer Support
To Next Page
Loading...
Need help?
General
