Name: Polaris 600 RUSH 2010
Brand: Polaris
Rating: 4 (1 reviews)

To Next Page

To Previous Page

2.35

Maintenance

ELECTRICAL SYSTEMS

Headlight Bulb Replacement

NOTE: Do not touch the bulb with your fingers. The

grease from body oil will cause a hot spot on the bulb

and cause bulb failure. If you do touch the bulb clean

the bulb with isopropyl alcohol.

1. Remove the hood assembly.

2. Locate the bulb connectors on the head lamp

assembly.

3. Rotate the connector counter-clockwise to remove

e bulb.

4. Install a new bulb by holding it in a clean shop rag or

pkin.

5. Install the connector into the head lamp and turn

clockw

ise.

6. Reinstall the hood assembly.

Tail Lamp Replacement

The rear tail lamp assembly uses light emitting diodes

(LEDs). LEDs cannot be replaced. The tail lamp assembly

must be replaced if an LED is not functioning.

Questions and Answers:

Need help?

Do you have a question about the Polaris 600 RUSH 2010 and is the answer not in the manual?

Polaris 600 RUSH 2010 Specifications

General