10.17
Battery and Electrical Systems
10
7. SECURE OFF displays if the system unlocks.
8. Immediately after locking and unlocking the
security
system, and while SECURE OFF is displayed, press
and hold the MODE button to bring up the enter code
screen.
9. When ENTER CODE displays, use the MODE and
SEL bu
ttons to select and accept each digit of a new
personal security code.
• SEL = Advances up 1 digit (0 to 9 to 0)
• MODE = Enter and move 1 digit to right
10. After pressing MODE to accept the last digit, view the
di
splay screen. The new code and CODE SET will
display if the system accepted the new code. If
successful, you will not see this screen again.
NOTE: If steps 9-11 are not completed immediately
a
fter performing the initialization procedure, the
security code will be 000. See Changing Security Code
to enter a new passcode.
11. Record the new security code in
a safe place (Owner’s
Manual or Customer RO) for future reference.
Security System: Locking
NOTE: Use the MODE button on the cluster when
performing procedure on models featuring the
analog/digital instrument cluster.
1. Start the engine in a well-ventilated area.
2. Hold the brake lever. Pr
ess and hold the MODE and
SEL buttons for 3 seconds, then release. SECURE
OFF should be displayed. If not, repeat this step.
• SEL = Advances up 1 digit (0 to 9 to 0)
• MODE = Enter and move 1 digit to right
3. When ENTER CODE displays, press and release SEL
to a
dvance the digit. When the first digit of your
security code is displayed, press and release the
MODE button to accept the digit and move to the next
digit.
NOTE: If the ENTER CODE screen exits due to
inac
tivity, repeat the locking procedure.
4. Continue to use MODE and SEL to select and accept
the r
emaining two digits of the security code.
To Next Page
Loading...
Need help?
General
