Name: Polaris 600 RUSH 2010
Brand: Polaris
Rating: 4 (1 reviews)

To Next Page

To Previous Page

6.17

PVT System

DRIVE CLUTCH

Identification

Every clutch will have the clutch part numbers etched on

to the cover (A). The “X" (B) marking is an index mark

where the clutch cover (C), clutch spider (D) and the

stationary sheave (E) should line up when the clutch is

assembled.

Drive Clutch Removal

NOTE: All clutch tools can be found at the beginning

of this chapter.

1. Remove the belt.

2. Place the clutch holding tool (PN 9314177-A) on the

ive clutch.

3. Remove the drive clutch retaining bolt. N

ote the

placement and number of washers on retaining bolt.

4. Insert the correct clutch puller into the retaining bolt

le.

5. Tighten the puller into the clutch. If the clutch does not

come off,

strike the clutch puller head with a hammer.

If the clutch does not “pop” off, continue to tighten the

clutch puller, and repeat this step.

CAUTION

Do not use an impact wrench to remove or install the

clutch bolt or clutch puller. Damage to the clutch and/or

crankshaft can occur.

Questions and Answers:

Need help?

Do you have a question about the Polaris 600 RUSH 2010 and is the answer not in the manual?

Polaris 600 RUSH 2010 Specifications

General