Name: Polaris 600 RUSH 2010
Brand: Polaris
Rating: 4 (1 reviews)

To Next Page

To Previous Page

8.25

Steering and Suspensions

Two Piece Throttle Control

Some models are equipped with a two-piece throttle

control on the handlebar. The two-piece throttle control is

designed to be serviced without having to remove the grip

and hand warmer element.

Removal:

1. Use a needle-nose pliers to extract the throttle cable

barrel out

of the throttle lever.

2. Loosen the throttle block set screw.

3. Remove the e-clip, the throttle lever pin and

djustment washers. Note the number of washers.

Remove the throttle lever.

4. Remove the screw from the aux

iliary stop switch

block. Remove or reposition the stop switch assembly

to gain access the cover screws.

5. Remove the throttle

release switch from the throttle

block. Note the orientation of the switch during

removal.

6. Slide the lower block out of the upper block. Remove

e throttle blocks from the handlebar.

Assembly:

Reverse removal procedure to assembly throttle block

asse

mbly. Torque fasteners to specifications.

= T

Throttle Cover Screws:

6 in-lbs (.6 Nm)

Auxiliary Stop Switch Mount Screw:

12 in-lbs (1.35 Nm)

Throttle Block Set Screw:

27 in-lbs (3 Nm)

Questions and Answers:

Need help?

Do you have a question about the Polaris 600 RUSH 2010 and is the answer not in the manual?

Polaris 600 RUSH 2010 Specifications

General