4.23
Cleanfire Fuel Injection
4
DC-CFI-2 FUEL INJECTORS/FUEL
RAIL
Fuel Injectors/Assembly
DC-CFI-2 engines feature a dual fuel injector/wiring
harness assembly. Fuel injector replacement requires
removing both fuel injectors/harness and installing a new
assembly. Fuel injectors are not supplied individually.
Harness cutting and splicing is not required.
NOTE: In addition to the fuel injector o-rings, an
is
olator o-ring (2011) or bushing is installed inside
each cylinder fuel injector bore.
To obtain the correct fuel injector set for the vehicle,
always re
ference the model-specific parts manual when
ordering a new fuel injector set. Note that fuel injector color
code may not match the fuel injector set original installed
on the engine.
2011 fuel injectors are different and not interchangeable
with other model years. Severe engine damage will
occur if the incorrect fuel injectors are installed.
O-RINGS (7.52MM ID)
2011 FUEL INJECTORS w/HARNESS
ISOLATOR O-RING (12.4MM ID)
O-RING (BROWN)
2012-2013 FUEL INJECTORS w/HARNESS
GREEN BUSHING
O-RING (BLACK)
Always verify the fuel injector color code with the fuel
calibration map loaded on the ECU.
Severe engine damage may occur if the incorrect fuel
injector calibration is loaded on the ECU.
To Next Page
Loading...
Need help?
General
